Tag Archives: creations

DSF Build Progress Eight


Almost there!

The heated bed is now complete! In my last update I was having issues with temperature readings. It turns out that the problem was the ply I used as an insulator. I cut the ply with a route for the nichrome wire to channel in and in the center is the thermistor. Because of the shape, a H shape, the ply had a defect that made the center bend away from the aluminium. As it done so it moved the thermistor away from the aluminium corrupting the reading. Also the nichrome wire was moving away from the bed causing hotspots where it burnt through the kapton tape.

Fire cemented

Fire cemented – little bit on the left is waiting to be filled, it is where the cramp was holding the H section tight to the aluminium.

To solve both these problems I used fire cement to fill the grove with the nichrome wire firmly attached. This means that now the heating wire is secure and the ply is held in position.

For the print surface I am using glass but it is borosilicate glass, from RepRapWorld.com. This glass apparently has a lower thermal expansion which, I believe, should reduce the likelihood of shattering due thermal shock. Given the low rates of heating and cooling I don’t think it would be likely occurrence, however I was ordering filament from them and it saves me getting glass cut to the right size and lets be honest “borosilicate” sounds cool!

All I am waiting on now is the hotend from E3D before I have a fully working system. It was a four week waiting time, although it may be here earlier according to the thread in RepRap’s forums.


Leave a comment

Filed under DSF

Creations Page

Just a short post to bring attention to my ‘Creations’ page on the blog. Here I will be listing my favourite things that I have designed and made. Check out the ‘Creations’ link at the top of the page!

Leave a comment

Filed under Musings