Tag Archives: prusa

Setting Up Megatronics

Steps per mm

Possibly the most exciting thing for me when building a 3D printer is the electronics. I have built 2 kits (a Huxley from eMaker and a Mendel from RepRapPro) and am now building my own design. Until any printer gets attached to its electronics it is a mere metal doorstop. What I wanted to write up about was how I calculated the steps per millimetre for the DSF.

While in my usual ‘I’m bored lets search the net’ mood, I stumbled across the excellent RepRap Calculator3 ┬áby Josef Prusa. If you are building a printer from scratch this will greatly simplify figuring out what number the steps per millimetres should be.

Like many of the printers out there my DSF uses belts for the X and Y axis’ (T5) and a lead screw for the Z (M5). For the belt drives all I needed to change was the belt preset to 5mm – or the T5 belt. The pulley I was using was already 8 teeth and 1/16th stepping. As a result this would give me 80 steps per millimetre or a 0.0125mm resolution.

The Z axis uses an M5 threaded rod as its drive so again all I needed to change was the preset to M5. This means a step of 4000 steps per millimetre or 0.00025mm resolution. Obviously that is much finer then any of the prints I would ever do, the finest I have done was 0.1mm/layer. In reality I could set the stepper to full steps and still retain a resolution of 0.004mm.

So thanks to the calculators I have a 80 steps/mm for X and Y and 4000 for Z. Ignore the 800 for the extruder above. I have not yet got an extruder so that is just place holding!

One last thing; I have limited the feedrate of the Z axis to a low 2mm per second. Any faster and the motors stall. I need to oil the threaded rod to try and get some extra speed out of it, but I am not holding my breath.

Leave a comment

Filed under DSF, Musings